Sanfix and Sanfix Fosta


Sanfix and Sanfix Fosta

Press connector systems for potable water installations in acc. with DIN 1988 and DIN 50930‑6 as well as heating installations, tested in acc. with DVGW worksheet534.

Press connectors
All sizes with SC‑Contur – accidently unpressed connections become visible during filling the system. The SC‑Contur is certified and fulfils the requirements of the DVGW worksheet534, point 12.14, Connectors with forced leakage.
During leakage tests with water Viega guarantees the identification of unpressed connections in the pressure range of 0.1 MPa–0.65 MPa, in the case of a dry leakage test with gases from 22 hPa–0.3 MPa.

Green dot on the press connection

Sanfix Fosta
  • PE‑Xc/Al/PE‑Xc pipe, dimensionally stable, oxygen-​tight in acc. with DIN 4726, white
  • PE‑Xc pipe, flexible, black

Press connector in combination with pipes
  • Sanfix Fosta: d 16/20/25/32/40/50/63
  • Sanfix: d 16/20

Area of use Sanfix Fosta
Potable water
Compressed air

Area of use Sanfix
Potable water

The use of the system for other than those described areas of application and media must be approved by the Viega Service Center.

Operating conditions
Potable water installations
  • Operating temperature max. 70 °C
  • Operating pressure max. 1.0 MPa
Heating installations
  • Operating temperature max. 8°C
  • Operating pressure max. 1.0 MPa
Irrelevant of the direction of flow, mixed installations are permitted.

The DVGW test mark is only valid for the use of original Viega parts - installation of non-​Viega parts is not permitted! The pipes conform to the recommendations of KTW (Plastic in potable water) of the German Federal Environmental Agency and the requirements of the DVGW worksheet W 270. Can be installed inaccessibly without restrictions in acc. with VOB-​C Point 3.2.7. Warranty and ZVSHK transferred liability agreement!

Sanfix Fosta and Sanfix
  • DVGW-​Reg.-No. DVGW-8803CU0136

Use of press tools
The functional safety of the Viega press connector systems primarily depends on the perfect condition of the press tools and press machines used. For this reason, for the production of press connections we recommend the use of Viega press tools and their regular inspection by authorised service points.

Technical data
More extensive information and technical data can be obtained from the download are of the Viega homepage:
Show more
Sanfix and Sanfix Fosta