Press connector with SC‑Contur
Inadvertently unpressed connections are noticed immediately during a leakage test.
Viega guarantees the detection of unpressed connections in the following pressure ranges with compressed air or inert gases:
min. air pressure: 22 hPa / 22 mbar / 0.3 PSI
max. air pressure: 0.3 MPa / 3 bar / 43.5 PSI
HNBR (hydrogenated acrylonitrile butadiene rubber), yellow, pre-assembled
The functional safety of Viega press connector systems depends primarily on the faultless condition of the press tools used. For the manufacture of press connections, Viega recommends the use of Viega press tools. Viega press tools have to be regularly maintained by authorised service partners.
Areas of application
Natural gas/liquid gas
The system components should be protected against high concentrations of chloride generated by both the medium and by external factors. Use of the system for areas of application and media other than those described must be agreed in consultation with Viega! Detailed information about applications, restrictions and national standards and directives can be found in the product information, either printed or on the Viega website.
Note – Standards and approvals
Press connector system with press connectors and pipes in accordance with DIN EN 10088, DVGW Worksheet GW 541.
Press connector approval for stainless steel in accordance with DG-8531BR0333.
Press connector approval for gunmetal in accordance with DG-8531BP0069.
Gases in accordance with DVGW G 260 in gas installations in accordance with DVGW-TRGI 2018 (DVGW Worksheet G 600) / DVFG-TRF 2012.
Liquid gases in the gas phase for domestic and commercial applications, tested in accordance with DVGW Worksheet G 5614.
Pipelines for heating oil in accordance with DIN 51603 and pipelines for diesel fuel as suction and pressure pipelines in accordance with DIN EN 590 in consideration of the General Building Approval Z-38.4‑1.
Operating conditions gas and liquid gas installations
operating temperature -20 °C to +70 °C (-4 °F to +158 °F)
operating pressure max. 0.5 MPa / 5 bar / 72.5 PSI
operating pressure at HTB requirements 650°C (1202 °F)/30 minutes max. 0.5 MPa (5 bar; 72.5 PSI)
Operating conditions heating oil and diesel fuel installation
operating temperature max. 40 °C / 104 °F
operating pressure -0.05 to +0.5 MPa (-0.5 to +5 bar / -7.25 to +72.5 PSI)
Material press connector
Stainless steel 1.4401
Pressure gradient calculator
Web application for quick and simple calculation of pipeline dimensions for potable water, heating and gas supply lines with associated pressure loss tables across the entire system.
This product description contains important information on choice of product and system, mounting, commissioning as well as intended use and, if required, on maintenance measures. This information on products, their features and application techniques is based on currently valid standards in Europe (e.g. EN) and/or in Germany (e.g. DIN/DVGW). Some passages in the text may refer to technical regulations in Europe/Germany. These should be considered as recommendations for other countries where no corresponding national requirements exist. The relevant national laws, standards, regulations, directives and other technical provisions take priority over the German/European directives specified in this product description: The information herein is not binding for other countries and regions and should be understood as recommendation.